EN-10058 pdf free download

EN-10058 pdf free download. Hot rolled flat steel bars for general purposes – Dimensions and tolerances on shape and dimensions.
1 Scope This European Standard specifies the nominal dimensions and the tolerances on dimensions and shape of hot-rolled steel flat bars for general purposes. This standard is not applicable to spring leaves, see EN 1 0092-1 . 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). EN 1 0079:1 992, Definition of steel products . EN 1 0088-1 , Stainless steels — Part 1 : List of stainless steels . 3 Terms and definitions For the purposes of this European Standard the terms and definitions given in EN 1 0079:1 992 apply. 4 Designation The designation of hot-rolled steel flat bars shall comprise:  the term ” flat bar”;  the number of this European Standard (EN 1 0058);  dimensions in mm (width x thickness x length (M, F or E, see Table 3));  the number of the quality standard and the steel name or steel number of the ordered steel. EXAMPLE Flat bar EN 1 0058 – 20x5x6000M steel EN 1 0025 – S235JR 5 Dimensions Hot rolled flat bars for general purposes complying with this European Standard shall be delivered with the specified dimensions range given in Table 1 and illustrated in Figure 1 . The preferred dimensions are presented in Table 1 . NOTE For manufacturing reasons the corners are not sharp. 6 Tolerances on dimensions and shape 6.1 Thickness ( t) The deviation from nominal thickness ( t ) shall be within the tolerance given in Table 2. 6.2 Width ( b ) The deviation from nominal width ( b ) shall be within the tolerance given in Table 2. 6.3 Length ( L ) Depending on the type of length, flat bars shall be cut to lengths within tolerances given in Table 3. 6.4 Straightness ( q ) The straightness shall comply with the requirements given in Table 2. The requirements for waviness may be agreed at the time of enquiry and order. 6.5 Out-of-section ( u ) The out-of -section ( u ) shall be within the tolerance given in Table 2. 7 Measurement 7.1 Thickness and width The thickness and width shall be measured at any point situated at least 1 00 mm from the end of the bar. Shearing may deform the bar ends, The condition of the ends may be agreed at time of enquiry and order. 7.2 Length The length shall be measured as the longest length of the bar. 7.3 Straightness The straightness shall be measured over the total length L of the bar. 7.4 Out-of-section The out-of-section shall be measured according to Figure 2 as the difference u on the nominal width b.EN-10058  pdf download.