BS EN 71-1 pdf free download

BS EN 71-1 pdf free download.Safety of toys — Part 1: Mechanical and physical properties.
2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. IEC 60126:1973, IEC reference coupler for the measurement of hearing aids using earphones coupled to the ear by means of ear inserts. IEC 60318:1970, An IEC artificial ear, of the wide band type for the calibration of earphones used in audiometry. IEC 60651:1979, Sound level meters. IEC 60804:1985, Integrating-averaging sound level meters. prEN ISO 868:1997, Plastics and ebonite — Determination of indentation hardness by means of a durometer (Shore hardness). EN ISO 3744:1994, Acoustics — Determination of sound power levels of noise sources using sound pressure — Engineering method in an essentially free field over a reflecting plane.EN ISO 3746:1995, Acoustics — Determination of sound power levels of noise sources using sound pressure — Survey method using an enveloping measurement surface over a reflecting plane. ISO 4287-2:1984, Surface roughness — Terminology — Part 2: Measurement of surface roughness parameters. ISO 4593:1993, Plastics — Film and sheeting — Determination of thickness by mechanical scanning. ISO 6508:1986, Metallic materials — Hardness test — Rockwell test (Scales A – B – C – D – E – F – G – H – K). ISO 7619:1986, Rubber — Determination of indentation hardness by means of pocket hardness meters. EN ISO 11201:1995, Acoustics — Noise emitted by machinery and equipment — Measurement of emission sound pressure levels at a work station and at other specified positions — Engineering method in an essentially free field over a reflecting plane. EN ISO 11202:1995, Acoustics — Noise emitted by machinery and equipment — Measurement of emission sound pressure levels at a work station and at other specified positions — Survey method in situ. EN ISO 11204:1995, Acoustics — Noise emitted by machinery and equipment — Measurement of emission sound pressure levels at a work station and at other specified positions — Method requiring environmental corrections.4 General requirements NOTE Words in italics are defined in Clause 3. Additional information is given in Annex C. 4.1 Material (see C.2) Toys and material used in toys shall be visually clean and free from infestation. The material is assessed visually by the unaided eye rather than under magnification. 4.2 Assembly (see C.3) If a toy is intended to be assembled by a child, the requirements in this part of EN 71 apply to each unit made available to the child and to the assembled toy. The requirements for the assembled toy do not apply to toys where the assembling provides a significant part of the play value of the toy. If a toy is intended to be assembled by an adult, the requirements apply to the assembled toy. Toys intended to be assembled shall be accompanied by detailed assembly instructions if appropriate. The instructions shall indicate if it is necessary that an adult assembles the toy or that the proper assembly is checked by an adult before use. BS EN 71-1  pdf download.