BS EN 6098 pdf free download

BS EN 6098 pdf free download. Aerospace series – Rod-end with bearing per EN 6097 in corrosion resisting steel, extra wide inner ring, external threaded shank – Dimensions and loads – Inch series.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2133, Aerospace series — Cadmium plating of steels with specified tensile strength ≤ 1 450 MPa, copper, copper alloys and nickel alloys
EN 2424, Aerospace series — Marking of aerospace products
EN 6097, Aerospace series — Bearing, spherical plain, metal to metal, extra wide inner ring in corrosion resisting steel — Dimensions and loads — Inch series
EN 6099, Rod-ends with plain bearing, metal to metal — Technical Specification1
ISO 1132-1, Rolling bearings — Tolerances — Part 1: Terms and dejmnitions
ISO 3161, Aerospace — UN] threads — General requirements and limit dimensions
ISO 3353-1, Aerospace — Lead and runout threads — Part 1: Rolled external threads
ISO 3353-2, Aerospace — Lead and runout threads — Part 2: Internal threads
ISO 8074, Aerospace — Surface treatment of austenitic stainless steel parts
MIL-PRF-23827, Grease, aircraft and instrument, gear and actuator screw, NATO code No.G-354 metric2
MIL-PRF-46010, Lubricant, solid film, heat cured, corrosion — inhibiting, NATO Code-S-i 7382
MIL-PRF-81322, Grease, aircraft, general purpose, wide temperature range, NATO Code G-3952
NAS 559, Lock-rod end (key type)3
4 Requirements 4.1 Configuration, dimensions, tolerances and mass Configuration, dimensions, tolerances and mass shall be according to Figure 1 and Table 1 and Table 2. Table 1: Dimensions and tolerances are expressed in millimetres (inches). Figure 1: Dimensions and tolerances for Ra max. are expressed in um (uin). Values apply after surface treatment. 4.2 Surface roughness Surface roughness shall be according with Figure 1. Surface roughness is measured before surface treatment. 6 Marking Marking shall be according EN 2424, style A. 7 Technical specification Technical specification shall be according to EN 6099. 8 Quality management system The manufacturer’s operations shall be an approved production organisation for aerospace products and shall demonstrate that it has implemented and is able to maintain a quality management system (e.g. according to EN 9100 or an equivalent aerospace accepted and established quality management system). The qualification procedure for aerospace standard products (e.g. according to EN 9133 or an equivalent aerospace accepted and established qualification procedure) shall be used and documented according to the specified tests if not otherwise agreed between customer and supplier.BS EN 6098 pdf download.