BS EN 6094 pdf free download

BS EN 6094 pdf free download. Aerospace series — Washer, spring, countersunk.
2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2424, Aerospace series — Marking of aerospace products EN 2516, Aerospace series — Passivation of corrosion resistant steels and decontamination of nickel base alloys EN 2540, Aerospace series — Steel FE-PM3902 (X7CrNiAl17-7) air melted, solution treated and precipitation hardened — Sheet and strip, a ≤ 6 mm, 1240 MPa ≤ R m ≤ 1450 MPa 1) EN 6088, Aerospace series — Stud 1) EN 6092, Aerospace series — Receptacle, floating, double lug 1) EN 6093, Aerospace series — Receptacle, floating, single lug 1) EN 6095, Aerospace series — Rotary fasteners — Structural and non-structural applications — Technical specification 1) EN 6105, Aerospace series — Stud with shoulder 1) EN 10088-2, Stainless steels — Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes ISO 2768-1, General tolerances — Part 1: Tolerances for linear and angular dimensions without individual tolerance indications SAE AMS 2700, Passivation of corrosion resistant steels 2) 3 Requirements 3.1 Configuration, dimensions, tolerances and mass The configuration, dimensions, tolerances and mass shall conform with Figure 1 and Table 1. Dimensions and tolerances are expressed in millimetres. Tolerances not specified shall be in accordance with ISO 2768-1. All dimensions and tolerances apply after surface treatment. All burrs to be removed / sharp edges to be broken. 3.3 Static values The washer shall be capable to withstand the loads given in Table 3 without permanent deformation. Load direction is outlined in Figure 2. NOTE Size code 19 must not be used in combination with quick release fastener system EN 6088, EN 6092, EN 6093 and EN 6105. 3.4 Operating temperature This washer shall be used in the temperature range of –55 °C to 150 °C. 5 Marking EN 2424, style G. 6 Technical specification EN 6095. 7 Example of installation See Figure 2 and Table 4.BS EN 6094 pdf download.